Maintenance of sliding door 45 degree cutting machine

Maintenance of the machine is very important. Necessary maintenance can not only extend the service life of the machine, but also reduce the risk of accidents and reduce maintenance costs. Let’s take you through the maintenance of the 45-degree sliding door cutting machine!

After the operation is completed, turn on the power and check whether all parts of the machine rotate flexibly and whether the fasteners are loose. Turn on the power and press the host button to see whether the blade direction is consistent with the direction of the arrow. After daily operation, rinse the rock residue on the surface of the studio and workbench with tap water and wipe dry. Every working day, the dirt on the machine tool and guide rails must be cleaned promptly to keep the machine bed clean. The air source and power supply must be turned off when leaving get off work, and the remaining air in the machine tool pipe must be evacuated. Regularly check the V-belt, power button and grinding wheel of the grinding wheel cutting machine for cracks.

Sliding door 45 degree cutting machine

If you leave the machine for a long time, turn off the power to prevent non-professionals from operating it. Pay attention to observe whether there is lubricating oil on the surface of the machine's horizontal and vertical guide rails and racks to keep them well lubricated. Regularly clean the oil stains on the carriage, guide rails and guide rail drive screws, and add lubricating oil in time. When clamping irregular rocks, the top pressure method can be used. When cutting core samples, if there are a large number of rocks, you can use the long pressing plate attached to press several rock samples and cut them together to improve work efficiency. If the cutting machine will not be used for a certain period of time after use, the moving parts of the blade and clamp and some places in the machine that are prone to rust should be coated with a layer of lithium.

Check whether all cutting torches are loose, clean the garbage from the ignition muzzle to keep the ignition normal, check whether the plasma cutting nozzle and electrode are damaged, and whether the cutting nozzle and electrode need to be replaced. After all the work is completed, move the blade forward about 10 cm to reset the rocker arm of the travel switch. Grease the spindle bearings regularly. During maintenance, first cut off the power supply and make a preliminary judgment on where the fault occurred. If the spindle bearing is severely worn, it should be replaced in time. Check the wear of the grinding wheel and whether there are cracks in time. Also check regularly whether the power button is flexible and replace it if it is damaged.

The above is the maintenance of the 45-degree sliding door cutting machine. Regular maintenance can not only improve the efficiency of the machine, but also reduce the damage to the machine and reduce maintenance costs. I hope the above content can be helpful to everyone!