Do you know how to maintain plastic door and window processing equipment?

Doors and windows are often used in our daily lives. Plastic door and window processing equipment is indispensable equipment in the production and processing of doors and windows. It brings convenience to the production and processing of doors and windows. In daily work, the maintenance of the equipment is very important, so everyone knows How to maintain plastic door and window processing equipment? Let’s take a look at it next!

The dirt on the machine tool and guide rails must be cleaned in time every day to keep the bed clean. Regularly check the components and fasteners of each mechanism to prevent loosening, and regularly check whether the equipment is grounded firmly. The positioning plate, working surface and jaws of the upper and lower press clamps should be kept clean and free of oil stains and wiped every shift. Remove debris falling on the sawing machine promptly to ensure accurate operation of electrical components.

Each sliding mechanism should use oil-free lubricating bearings or linear motion bearings. Pay attention to whether there is lubricating oil on the surface of the machine's horizontal and vertical guide rails and racks, and lubricate all parts regularly. The power supply system at the site where the equipment is located must be inspected regularly, and the cable connections must be reliably insulated and wrapped with tape. The PTFE welding cloth wrapped around the heating plate must be replaced regularly. Check the performance of all buttons and selector switches frequently and replace them if damaged.

Remove debris falling on the sawing machine promptly to ensure accurate operation of electrical components. The filter element and water storage cup of the water separation filter in the air source processor should be cleaned and drained regularly. The electrical box should be kept clean and dry, and there should be no moisture or corrosive gas around it to avoid damage to the equipment. If it is not used for long-term storage, it should be rust-proofed before packaging to avoid corrosion.

The above is the maintenance of plastic door and window processing equipment. Proper maintenance of the equipment can not only reduce the risk of equipment accidents, but also extend the service life of the equipment and increase work efficiency. I hope the above content can be helpful to everyone. Welcome to call us for consultation!