Maintenance and upkeep of 45-degree sliding door cutting machine

Machine maintenance is crucial. Proper maintenance not only extends the machine's lifespan but also reduces potential accidents and lowers repair costs. Below, we'll guide you through the maintenance of a 45-degree sliding door cutting machine!

After operation, connect the power supply and check if all parts of the machine rotate freely and if all fasteners are loose. Connect the power supply and press the main unit button; check if the blade rotation direction matches the arrow. After daily operation, rinse the working chamber and worktable surface with tap water to remove rock debris and wipe them dry. Clean the machine tool and guide rails regularly each workday to keep the machine bed clean. At the end of the workday, turn off the air supply and power, and purge any residual air from the machine tool hoses. Regularly check the V-belt, power button, and grinding wheel of the abrasive cutting machine for cracks.

If leaving the machine unattended for an extended period, turn off the power to prevent unauthorized operation. Observe the surfaces of the machine's horizontal and vertical guide rails and racks for lubrication, ensuring proper lubrication. Regularly clean oil stains from the slide, guide rails, and guide rail drive screws, and add lubricating oil as needed. When clamping irregular rocks, use a top-pressure clamping method. When cutting core samples, if there are many rocks, use the provided long pressure plate to press several rock samples down for simultaneous cutting, improving efficiency. After using the cutting machine, if it will not be used for a certain period, apply a layer of lithium to the blades, moving parts of the clamps, and any easily rusted areas inside the machine.

Check all cutting torches for looseness, clean debris from the ignition nozzle to ensure proper ignition, and check the plasma cutting nozzle and electrode for damage and replacement. After all work is completed, move the blade forward approximately 10 cm to reset the limit switch rocker arm. Regularly lubricate the spindle bearings. During maintenance, first disconnect the power supply and determine the location of the fault based on initial assessment. If the spindle bearing is severely worn, it should be replaced promptly. Regularly check the wear and cracks of the grinding wheel, and periodically check the power button for smooth operation; replace any damaged buttons.

The above covers the maintenance of a 45-degree sliding door cutting machine. Regular maintenance not only improves machine efficiency but also reduces damage and repair costs. We hope this information is helpful!